600 SRM 496
Flywheel Repair H1.50-175XM, H2.00XMS (S/H25-35XM, S/H40XMS)
Flywheel Repair H1.50-175XM, H2.00XMS (S/H25-35XM, S/H40XMS)
REMOVE
1.
Remove capscrews for flywheel. Then remove fly-
wheel and flange. See Figure 51.
2.
If necessary, remove adapter plate.
INSTALL
1.
If adapter plate for the torque converter hous-
ing was removed, install it on engine. See Fig-
ure 51. Tighten capscrews to 43 to 51 N•m (32 to
38 lbf ft).
2.
Install flange and flywheel on crankshaft.
3.
Apply thread-locking adhesive on threads of cap-
screws. Then install capscrews and lockwash-
ers. Tighten capscrews to 96 to 103 N•m (71 to
76 lbf ft).
NOTE: EARLIER MODEL TORQUE CONVERTER HOUSING IS SHOWN. LATER MODEL IS SIMILAR.
1.
FLANGE
2.
FLYWHEEL
3.
DRIVE PLATE
4.
TORQUE CONVERTER
5.
ACCESS COVER
6.
TORQUE CONVERTER HOUSING
Figure 51. Flywheel and Torque Converter
23
