S5 BDI Startup Full
NOTE:
* If OTHER is selected as Battery Type,
BDI functions will be disabled.
This parameter will be automatically set to the cor-
rect value when the "Battery Type" parameter is
set. However, this parameter can be used by the
user to adjust the number of BDI bars which the
display will show immediately after re-key based
on battery voltage. A "1" equals the lowest voltage
setting for a given number of bars and a "9" equals
the highest voltage setting for a given number of
bars. This does not affect the discharge rate of the
battery, only the initial number of bars displayed
after re-key.
S6 BDI Full
NOTE:
* If OTHER is selected as Battery Type,
BDI functions will be disabled.
This parameter will be automatically set to the cor-
rect value when the "Battery Type" parameter is
set. However, this parameter allows the user to ad-
just the battery voltage which the truck software
considers to be "10" BDI bars. A "0" equals a lower
voltage and a "9" equals a higher voltage.
S7 BDI Empty
NOTE:
* If OTHER is selected as Battery Type,
BDI functions will be disabled.
This parameter will be automatically set to the cor-
rect value when the "Battery Type" parameter is
set. This parameter allows the user to adjust the
battery voltage that would correspond to "0" BDI
bars. A "0" equals a lower voltage and a "9" equals
a higher voltage.
S8 BDI Reset
NOTE:
* If OTHER is selected as Battery Type,
BDI functions will be disabled.
This parameter will be automatically set to the cor-
rect value when the "Battery Type" parameter is
set. This parameter allows the user to adjust the
change in battery state-of-charge required to reset
the BDI back to 10 bars.
S9 Lift Interrupt
Use this parameter to ENABLE or DISABLE the
lift interrupt. This will cause the lift truck to disa-
ble lift function when the BDI bars read 0 (approxi-
mately 80% battery discharge) when set to ENA-
BLE.
S10 Audible Warning
Use this parameter to enable or disable the audible
motion alarm and select the condition/s when the
alarm will be active. One of sixteen different combi-
nations of activities for when the alarm will sound
can be chosen by this parameter. Setting the pa-
rameter to “0” will disable this function.
0. Disable audible warning and its diagnostic
1. Reverse travel (default from factory)
2. Forward travel
3. Forward travel OR reverse travel
4. Lifting
5. Reverse travel OR lifting
6. Forward travel OR lifting
7. Forward OR reverse travel OR lifting
8. Lowering
9. Reverse travel OR lowering
10. Forward travel OR lowering
11. Forward OR reverse travel OR lowering
12. Lifting OR lowering
13. Reverse travel OR lifting / lowering
14. Forward travel OR lifting OR lowering
15. Forward OR reverse travel OR lift OR lower
16. Continuous
S11 Visual Warning
Use this parameter to enable or disable the visible
motion alarm and select the condition/s when the
alarm will be active. One of sixteen different combi-
nations of activities for when the alarm will sound
can be chosen by this parameter. Setting the pa-
rameter to “0” will disable this function.
0. Disable visual warning and its diagnostic
1. Reverse travel (default from factory)
2. Forward travel
3. Forward travel OR reverse travel
Service-Level Menu
2200 SRM 1631
12
