Steambrite Supply
Steambrite Supply
Created on: : Monday 20 September, 2021
>
Cage Extractor under
three webs of the Valve
Cage and pull up with a
twisting motion.
To remove Valve Seat.
Hook Valve Seat Extractor
under Seat and work out
with an up and down
motion.
5. Rotate the Pump Shaft so the Cam Bearing is in
the upstroke position; then using a 3/16’’ Allen
wrench, remove the Cap Screw from the Piston
Assembly for Models 5300X and 5324 [For Models
5321 & 5322, remove the Plunger from the Pump
Body after the Cap Screw is removed].
6. Turn the Pump over and repeat Steps 1 through 5.
7. Position the Pump horizontally in the vise with the
Safety Cover side up.
8. Use a claw hammer to remove the Grease fitting
(See Figure 11). In most cases, the Grease Fitting
is damaged during removal and must be replaced
[At this time, remove the Connecting Rod in
Models 5321 & 5322].
Figure 11
Piston Sleeve Assembly Removal and
Cleanup (5300X and 5324 only)
See Figures 12 & 13 for Piston Stack Components
Cap Screw
Washer
O-ring
Cup Spreader
Cup
Cup Backing Plate
O-ring
Seal Ring
Guide
Figure 12
Cap Screw
Washer
Support Ring
Cup
Cup Holder
O-ring
Seal Ring
Guide
Figure 13
-7-
1. Leave the pump body horizontal in the bench vise
to remove the Cylinder Sleeves and Piston
Assemblies. Make sure the Cam Bearing is in the
Steambrite Supply - 210 662 9000 - [email protected] Page 10/32
