16
© Copyright 2018 HYPERVSN. All rights reserved
3.
Firmly screw-in the binding screw inside the rotor (the binding screw is spring
loaded):
•
Put the screwdriver into the screw hole (Picture
•
Push in the binding screw in until it stops
•
Tighten the binding screw until it stops by turning to the right.
Important. For Model M Devices do not apply excessive force. This may damage
the rotor.
Picture 8. Tightening the binding screw
If the assembly steps are performed correctly, there will not be any backlash of
the stator or rotor elements.
4.
Push the switch on the stator to the right (this will allow to launch the Device
without the remote control).
Picture 9. Position of the switch
Repeat the assembly procedure for each Device of the Wall.
The Devices start working the second that they are plugged in. Before
switching on the Devices, ensure that every person near the Wall keeps
a safe distance of at least 0,5m.
RIGHT
POSITION