PAC200T/E TORCH HANDLE REPLACEMENT
Field Service Bulletin
2
0
Remove Handles
1.
Disconnect power and remove torch lead from power supply.
See
Section 3
of the Instruction Manual.
2.
Remove consumables.
3.
Remove screws using a #2 Phillips screw driver and discard screws.
4.
Remove handles.
Note:
Open handles slowly so that the trigger spring is not lost.
PAC200T
PAC200E
Install Handles
1.
Place CE/CSA label on right handle.
Place PAC200T or PAC200E label on left handle as appropriate.
2.
Place torch into right handle and route wires as shown above.
Note:
Route start switch wires underneath the torch body gas tubes.
3.
Place trigger and trigger spring into handle as shown above.
4.
Attach left handle with the supplied screws using a #2 Phillips screw driver.
Note:
Verify that the start switch wires will not be pinched when the left handle is attached.
5.
Connect torch lead to power supply and connect power.
See
Section 3
of the Instruction Manual.
6.
Verify that the Cap Off sensor works properly.
1.
Install consumables but leave the retaining cap loose.
1.
Turn On the power supply.
2.
Shield Gas/Cap LED should illuminate.
3.
Turn Off the power supply.
4.
Tighten retaining cap.
