HyperFlight
Sokol Assembly Guide
Wing
Dry fit the aileron servo in the circular opening in the centre of the wing, to identify the
optimum position. Check that the fuselage will not foul the servo. If all okay mark the
servo position.
Make a mount for the aileron servo from a scrap piece of 1/8” (3mm) or 3/6” (5mm)
balsa. Epoxy this in position, and then epoxy the servo to the mount. Make up short
pushrods from 18 SWG or 20 SWG piano wire with L bends at the ends. Use keepers
or small tubes to hold the pushrods in position.
(c) 2013 HyperFlight Drybank Farm Fosse Way Ettington Stratford-on-Avon Warwickshire CV37 7PD
6
