1. Be sure all detergent is flushed from system.
2. Turn off motor.
3. Turn off water supply.
4. After motor and water supply are turned off, trigger gun to depressurize system.
CAUTION:
NEVER turn water supply off before turning motor off. Serious damage could occur to the
pump and / or motor.
WARNING!
NEVER disconnect high pressure discharge hose from machine while system is pressur-
ized. To depressurize, turn motor off, turn water supply off and squeeze gun trigger 2-3 times.
5. After each use, wipe all surfaces of the pressure washer with a clean, damp cloth.
Regular maintenance will improve performance and extend life of Pressure Washer. Pressure
Washer’s warranty does not cover items that have been subjected to operator abuse or negli-
gence. Only by maintaining Pressure Washer in accordance with instructions in this manual will
the full value of the warranty be honored.
Some adjustments will need to be made periodically to properly maintain the Pressure Washer.
All service and adjustments should be made at least one time each season. It is important that
the maintenance chart below be followed.
MOVING AND STORAGE
After each application or winter storage follow these instructions:
1. When finished using the Pressure Washer, you must first drain and rinse the detergent tank.
2. Run the Pressure Washer in low pressure until all of the soap is drained from the detergent tank.
3. Pour clear water into the tank and run it through on low pressure as though it were detergent.
4. Turn the machine OFF and squeeze the trigger to release the trapped pressure inside of the
machine.
5. Remove both the garden hose and pressure hose from the unit.
6. Turn ON the machine and allow it to run for 5 seconds. (This will clear out most of the water trapped
in the pump).
7. Unplug the machine and store in a dry, climate controlled environment.
NOTE:
Do not store the machine or accessories in a place where the temperature could drop below
40°F.
Do not store pressure washer outdoors.
Do not store pressure washer where it might freeze.
AFTER EXTENDED STORAGE
Scale deposits may form in the pump when it is not used for some time. This causes the motor to
hesitate or not start up at all.
1. Do not plug the unit into electrical outlet or connect the pressure hose to the unit.
2. Connect garden hose to the unit and allow the water to exit from high pressure outlet for a few
seconds to rinse the system.
3. Shut off the water.
4. Connect pressure hose to the gun and then lock hose safety device.
TIPS FOR EXTENDING THE LIFE OF YOUR PRESSURE WASHER
1. Never operate unit without water.
2. Pressure washer is not meant to pump hot water. Never connect to hot water supply – this will
significantly reduce life of the pump.