HYOSUNG RT125D - PARTS CATALOGUE, Owner'S Manual

Page: 63 / 73

62
◉ ◉
TROUBLE SHOOTING
If the engine refuses to start, perform the
following inspections to determine the
cause.
● ●
Fuel Supply Check
①
Is there enough fuel in the fuel tank?
②
Is the fuel reaching the carburetor from
the fuel cock?
③
Disconnect the fuel line from the
carburetor, turn the fuel cock to the
“ ON ”
position and see if gasoline flows from
the hole.
④
If it has been determined that fuel is
reaching the carburetor, the ignition
system should be checked next.
● ●
Ignition System Check
①
Remove a spark plug and reattach to the
spark lead.
②
While holding the spark plug firmly
against the crankcase of the engine,
push the starter switch with the ignition
switch in the “ON” position, the engine
stop switch in the “ ” position, the
transmission in neutral and the clutch
disengaged.
If the ignition system is operating
properly, a blue spark should jump a
cross the spark plug gap.
③
If there is no spark, clean the spark plug.
Replace it if necessary. Retry the above
procedure with the cleaned spark plug or
new one.
④
If there is still no spark, consult your
Hyosung dealer for repairs.
WHEN THE ENGINE REFUSES
TO START
Do not allow the fuel to spill.
Catch the fuel in container.
Do not allow any fuel to come in contact
with the hot engine or exhaust system.
Extinguish any smoking materials
before performing this check, and stay
away from any other fire or heat source.
CAUTION
Performing the spark test improperly
can cause a high voltage electrical
shock or an explosion.
Avoid performing this check if you are
not familiar with this procedure, or if you
have a heart condition or wear a
pacemaker. Keep the spark plug away
from the spark plug hole during this test.
WARNING