G.
General Trouble Shooting
* Troubles:
-
Tool does not run at a normal speed or at a variable speed
-
The motor blocks
-
Automotive start when connected to compressed air
-
Torque reduces
-
Abnormal vibrating -Easy hot rising at the housing
* Causes:
-
Air supply is not enough (air pressure not in a required standard)
-
Speed controller/switch breaks down
-
Rotor blades break or wear out
-
Dust gets into the motor
-
Throttle lever or starting trigger malfunctions
-
Air leakage at the inlet or somewhere else
-
Bearing(s) damages
-
Correspondent O-ring(s) wears out or out of position
-
Lack of lubricating
* Troubles Shooting:
-
Check the air hose to see whether it is blocked or twisted for less air supply.
-
Check the air compressor to gain the correct air pressure required.
-
Replace rotor blades
-
Disassemble the tool and clean the inner structure under proper instructions
-
Check and fix the throttle lever or starting trigger for accurate operation
-
Check the air leakage and fix it under proper instruction
-
Replace new bearing(s)
-
Replace the damaged O-ring(s) or put it back in correct position
-
Oil / Lubricate the tool consistently until it gains the right speed and torque
* Note: For any other special troubles which cannot be settled down by the operator,
please contact the selling agent from whom you purchase the tool.
H.
Storage
Avoid to store the tool in a location subject to high humidity, which may result in rusty
mechanism inside the tool. Before storing, oil the tool at the air inlet with proper
Spindle oil and run it for a few seconds.
I.
Disposal
When the tool is seriously damaged or out of life, leave it in a resource recycling can.
Never drop it into fire.
J.
Ordering Spare Parts
1. Contact the sale agent from whom you purchase the tool for spare parts ordering for
any necessary replacement for continuous use of tool and extending the tool life.
2. In ordering spare parts and components, give each spare part number and order
quantity.
Thank you.
