INSTRUCTIONS
www.hydrotek.ca
WE RECOMMEND THE FOLLOWING AIR FILTER MAINTENANCE
PROCEDURE ON A REGULAR BASIS
1. LOOSEN SCREW ON FRONT PANEL
2. GENTLY REMOVE FRONT PANEL
3-4. LOOSEN FILTER SCREWS AND REMOVE FILTER
5. LIFT AND REMOVE SIDE PANEL
6-7. LOOSEN SCREW ON SIDE PANEL AND REMOVE
FILTER
8.
REMOVE DUST WITH BRUSH, VACUUM, OR RINSE
WELL WITH WATER. DRY THOROUGHLY BEFORE
REINSTALLING THE PARTS IN REVERSE ORDER.
TROUBLESHOOTING
SYMPTOM
CAUSE
SOLUTION
The unit doesn’t run and
the display is blank
Power is not turned on
Turn on the power
Plugged in incorrectly
Be sure the power cord is fully plugged
in
The unit cycles on and off
Wrong voltage and/or frequency
Apply to correct power source
Chiller is in protection mode
A. Check if the water circulation is
normal
B. If the fan and the Chiller dissipate
heat normally, wait for 3 minutes and
the unit will automatically turn on
again
Performance is
decreased or there is no
refrigeration
Fan is not working
Return to place of purchase
The set temperature is higher
than the aquarium water
temperature
Reset temperature
The air inlet or outlet are clogged
Clean the air inlet/outlet with a brush
or a vacuum cleaner
Loud Operation
Not installed on a flat surface
Reinstall correctly
