24
“Operation & Maintenance Manual”, “Discfilter HSF2600 series”
6.6.3 Checking drum bearing wear
1. Turn the main power switch to the OFF (0) position and lock with a padlock.
2. Drain the filter basin.
3. Check the drum bearings for wear. If the distance between the bearing housing (A) and
the shaft (B) is less than 29 mm (see Figure 6.12), the drum bearing must be replaced.
4. Contact your supplier if the drum bearing needs to be replaced.
5. Start operations again as set out in section 4.1.
Figure 6.12
Drum bearing on inlet side.
A
B
29-34 mm
A. Bearing
housing
B. Shaft
