Hydrotech Water 15010670, Installation And Operation Manual, Page: 3 / 26

3
Proper Installation
This water filter system must be properly installed and located in accordance with the
Installation Instructions before it is used.

Install or store where it will not be ex-
posed to temperatures below freezing or
exposed to any type of weather. Water
freezing in the system will break it. Do not
attempt to treat water over 100°F.

Do not
install in direct sunlight. Excessive
sun or heat may cause distortion or other
damage to non-metallic parts.

Properly ground to conform with all gov-
erning codes and ordinances.

Use only lead-free solder and flux for all
sweat-solder connections, as required by
state and federal codes.

The water filter system requires a mini-
mum water flow of three gallons per mi-
nute at the inlet.

Maximum allowable inlet water pressure is
125 psi. If daytime pressure is over 80
psi, night time pressure may exceed the
maximum. Use a pressure reducing valve
to reduce the flow if necessary.

WARNING:
Discard all unused parts and
packaging material after installation. Small
parts remaining after the installation could
be a choke hazard.