HYDROSCAND PowerCut 5-85ot, User Manual

Page: 8 / 31

Page 8
PowerCut 5-85OT USER MANUAL EDITION II 2017-09-08
1. Foot pedal
2. Waste box
3. Adjustable feet
4. Motor
5. Bend support
6. the Hold counter button
7. the emergency stop push button
8. the on/off button
9. Counter with reset button
10. Hose bending system on/off
hose bending system on/off. On when cutting 1 ½” and above, multispiral hoses. On when
cutting 2” and above, braided hoses.
11. Cuttin stroke switch
A three ways switch. Preset return levels for the bending unit. The cylinder is stopped at
specified levels to prevent it from doing full return strokes when not necessary.
12. The Front hatch
The front hatch is operated by a pneumatic cylinder located at the top of the machine. The
hatch has a two way switch (Auto and Down). When “down” is chosen the hatch stays down
at the whole cutting process. When “auto” is set the hatch is normally open but will auto-
matically go down when the foot pedal is pressed to start the cut. The hatch will come
down as a protection before the hose will be pressed down and cut. The hatch will automa-
tically open after the cut is made.
13. Cutting speed
Adjust according to hose diameter, reinforcement, material etc.
14. Lifting hole