CS7500/CS6500 - BASIC OPERATION
Pump 1 Key:
Press this key once to turn Pump 1 onto Low speed, press this key a second time to turn
Pump 1 onto High speed, a third press will turn the pump off. A built-in timer will shut the pump off after 20
minutes of operation unless done so manually. The Pump 1 indicator will illuminate while the pump is
running in High speed and flash while it is in Low speed.
Pump 2/Blower Key:
Press this key once to activate Pump 2 or Blower. A built-in timer will shut the
device off after 20 minutes of operation unless done so manually. The indicator will illuminate while the is
running is running.
Light/Enter Key:
Press this key to turn the light on, a second press will turn the light off. If light circuit is
set to two intensity light in the Low Level Setting first press will activate low intensity, second press will
activate full intensity. The light will automatically shut off after 2 hours.
Temperature Set Key:
Press the Up/Down Arrow key to increase the desired temperature, release and
press again to decrease the desired temperature. The temperature can be adjusted in 1°F increments
from 59°F to 104°F (5°C to 40°C). The new setting will remain on the display for 5 seconds as a
confirmation. During this time the Temperature Program indicator will be illuminated to let you know this
is the desired and not the actual temperature. After 5 seconds the display will return to the current
temperature reading. When the temperature drops to 1°F below the set temperature, the heater will be
turned on until the temperature is 1°F above the set temperature. The Heater “On” indicator will
illuminate while the heater is on and flash when there is a call for heat and the heater has not yet been
activated or is dis-abled due to current limiting .
85-0150-B REV.07 02/16
TEMPERATURE SET KEY
LIGHT KEY
ACCESSORY KEY
PUMP 1 KEY
INDICATOR
LIGHTS
LED FUNCTION
