Hydronix Hydro-Hub, User Manual

Page: 54 / 75

Chapter 6 Sensor Setup
54 Hydro-View / Hydro-Hub User Guide HD0864 Rev 1.0.0
2.4
Diagnostics
Figure 78: Diagnostics Selector
The diagnostics section is divided into two sections: Live Data and Hardware Test. This enables
the user to diagnose any possible faults with the sensor.
Sensor status
Sensor Output Status
Current resonator
frequency
response
Figure 79: Diagnostics
2.4.1 Resonator
The Resonator Graph displays the current frequency response of the sensors resonator.
The resonator response can be helpful in determining if a sensor is operating correctly.
The frequency and amplitude response should always be within the factory Air and Water
values (Page 51). With the sensor clean and with no obstructions in front of the ceramic face
plate the frequency and amplitude should be very close to the factory Air value. When a
hand is placed on the ceramic face plate the frequency and amplitude should be within the
Factory Air and Water range. Contact Hydronix support for assistance if the sensor does not
operate within the Air/Water span. support@Hydronix.com
Figure 80 shows the typical resonator response with the sensor in air and with a hand on
the ceramic (Some sensor will display the graph as a peak instead of a trough).