Page 6
1.4 Intended Use
HygroMatik electrode steam humidifiers
serve for steam production based on tap
water or partially softened water.
Only use supply water featuring a con-
ductivity of 125 to 1250 µS/cm.
D1: Lower threshold
C1: Range of reduced conductivity
(adjustment required)
A: Normal Tap water
B: Range of increased conductivity
C2: Range of high conductivity
(adjustment required)
D2: Upper threshold
In the C1 and C2 ranges, adaptation of the
periodic blow-down frequency may be
required. Pls. refer to parameter „2-1“ and „2-
2“ explanations given in the „Detailed param-
eter descriptions“ section.
The following applies to the
StandardLine
device series: Please read the explanations
of parameters "2-1" and "2-2" in the section
"Detailed parameter descriptions" in this
manual.
Proper usage also comprises the adherence
to the conditions specified by HygroMatik for:
•
installation
•
dismantling
•
reassembly
•
commissioning
•
operation
•
maintenance
•
disposal.
Only qualified and authorised personnel may
operate the unit. Persons transporting or
working on the unit must have read and
understood the corresponding parts of the
Operation and Maintenance Instructions and
especially the chapter 2. „Safety Notes“.
Additionally, operating personnel must be
informed of any possible dangers. You
should place a copy of the Operation and
Maintenance Instructions at the unit‘s opera-
tional location (or near the unit).
By construction, HygroMatik steam humi-
difiers are not qualified for exterior appli-
cation.
Risk of scalding!
Steam with a temperature of up to 100 °C
(212° F) is produced.
Do not inhalate steam directly!
