7
or can be obtained from
Hydromatic factory.
8.
IMPORTANT:
Do not use
any of the old seal parts.
Replace with all new seals.
NOTE: Any time seal is
disturbed, replace seal.
9. Thoroughly clean all castings
be fore re plac ing seals. One
grain of dirt between the seal
faces can cause failure.
10.Examine all O-rings for nicks
be fore re us ing.
11.Use Locktite (red) on socket
head locking screw in end of
shaft.
12.Before refilling chamber with
oil, air test as described in
replacing stator.
13.Refill both chambers with oil
as described in replacing stator.
14.Always check all leads with
high voltage or with Megger
for grounds before operating
the pump.
15.Check pump for proper
rotation before re
turn
ing to
normal ser vice.
Pump
Notes
______________________________________________
______________________________________________
______________________________________________
______________________________________________
______________________________________________
______________________________________________
______________________________________________
______________________________________________
______________________________________________
______________________________________________
______________________________________________
______________________________________________
______________________________________________
______________________________________________
Summary of Contents for S4HVX Series
Page 9: ...9 S4HVX ...
Page 15: ......
