The information contained herein is intended for the use of the individual(s) named above and those authorized to receive it. Dissemination, distribution
or copy of this information is strictly prohibited.
A.
Stand both sets of “A1” & “A2” panels firmly together. Fasten the panels together through the holes
provided on the inside of the panels using hex headed screws. Make sure the panels are pulled tightly
together before tightening the screws. (For best results, insert a bead of silicone caulk into the inside
bend of the “A1” panel flanges.)
B.
Assemble each “B-A1-A2-B” (side-end-side) assembly through the holes provided using hex headed
screws. Set them on the marked concrete base (Fig. 2). (For best results, insert a bead of silicone caulk
into the inside bend of the “A#” panel corners.)
3.
Inspect the alignment of the “C” (access) panels during the assembly process. Verify that their
removal and replacement allows adequate space and positioning within the openings and with the
adjacent panels prior to attaching any bracket to the concrete.
NOTE: model sizes and configurations vary, see the chart.
4.
Set a “D1” (roof) panel on a “B-A1-A2-B” (side-end-side) assembly using the “C” (access) panels for
temporary roof support if needed. Fasten the “D1” (roof) panel to the “B-A1-A2-B” (side-end-side)
assembly through the holes provided (Fig. 1) using three (3) hex headed screws.
A.
Insert an Inside Roof Clip into the “D1” (roof) panel at the “A2” panel stud (Fig. 1C). Attach the clip to
the “A2” panel stud as shown using one (1) hex headed screw.
B.
Repeat 4 and 4A for the other “D1” (roof) panel and “B-A1-A2-B” (side-end-side) assembly.
