P/N 20-07665-00 Rev
L
© Hydro Systems Company, Inc. 201
8
HydroSystemsCo.com Toll Free: 1.800.543.7184 10
Programming
Filter Duration “Fd”
Press the Enter key to view/set Signal Filter Duration (same input method as Password input). The available
range is 0-19 seconds; the default is 3 seconds).
NOTE
: In Occurrence Mode, set the Filter Duration time long enough to filter out excess fill valve signals that
may occur as the washer level control calls for more water, etc. Automatic and Relay modes typically use the
default setting.
User Prime “uPr”
Every 2 seconds, the screen alternates between UPr and current User Prime setting (on or off). Press the
Enter Key to change this setting.
Password Edit “Pin”
Any three-digit number may be input. Press the Scroll Key to change the blinking digit to the desired value.
Press the Next Key to move the blinking digit. Repeat for all digits and press the Enter Key when the desired
password is present.
NOTE
: Note any password changes! Access to Program Mode is not available if the password is lost!
Exit Program Mode “End”
Press the Enter key to exit Program Mode and return to User Mode.
NOTE
: To clear all values and restore factory settings, press and hold the Scroll key for two seconds, then
press the Enter key (while still pressing the Scroll key). “FAC” will appear to indicate that you have restored
factory settings and cleared the dispenser’s memory (including counter reset to zero). Press the Enter key
again to return to User Mode.
Figure 8 Program Mode Screens
Figure 9 Key Icons
Figure 10 Set Numerical Display
