Hydro International Hydro-Logic Flexi Logger 300Ex, User Manual

Page: 16 / 74

Hydro-Logic
®
Flexi Logger 300Ex
User Manual
22 August 2018 Page 16 of 74
Recording test data from the sensor
If you have ordered the Pre-wiring and configuration service , the sensor can
immediately be connected to the connectors labelled S1 to S3 on the logger
body.
If you need to wire your own sensor, see the section Sensors for more
information.
Once the sensor is connected, you should ensure that the clock is reset (either by
Resetting logger clock with Timeview or Resetting the logger clock with Harvest)
This will clean any blank data points that were recorded with no sensor
connected, and ensure that data points from the sensor are correctly time-
stamped.
Now leave the logger to record some data. The logger will be configured to take
measurements every 5 or 15 minutes, so leave it for half an hour or so.
Finally, either press the dial-out button to send data to Timeview or read the
logger with Harvest.
You should now see data points from your sensor(s) in the
Harvest plot or the Timeview Logger Profile .