Step 3
Mount the System Head
1. Select an easily accessible area under the sink to mount the filter system.
2.
Note: Mount system to a solid cabinet wall or wall. If this is not an option, use toggle bolts or hollow-wall
anchor bolts (not included) to secure the system to the surface
.
3.
Note: Allow a minimum clearance of 4”-6” below the filter cartridges to allow ample space for cartridge
changes. The filter system must be mounted in a vertical position.
4. Use the back panel as your mounting template, marking the holes for the mounting screws on the wall
surface.
5.
Drill two pilot holes for the mounting screws using a 1/8” drill bit. Insert mounting screws into the wall
with a Philips screwdriver, leaving approximately 3/8” of each mounting screw exposed.
6. Position the system head on the eyes of the bracket.
Step 4
Install White Plastic Tubing for Water Supply Line from Kitchen Faucet Adapter Valve to System Head Inlet
1. Determine the length of white tubing (
C4
) necessary to connect the system head inlet to the kitchen
faucet adapter making sure to allow enough tubing to prevent kinking in the line.
2. Cut the tubing squarely on both ends. Use a tubing cutter to ensure a square cut.
3. Without bending or crimping it, wet one end of the tubing with water and push it into the kitchen faucet
adapter approximately 5/8” until it stops.
4. Wet the other end of the tubing with water and push it into the system head inlet on the left side of the
manifold approximately 5/8” until it stops.
5. Prevent tubing from coming loose from fittings by inserting a clip (
C7
) as shown in the illustration below.
(Elbow fitting in image not included.)
