HydraMaster RX20 NEXTGEN 120 VAC, Owner'S Manual, Page: 52 / 57

9-5: Owner’s Manual
HANDLE LATCH ASSEMBLY: LATCH PLATE REPLACEMENT AND
ADJUSTMENT INSTRUCTIONS
Refer to HydraMaster Engineering Assembly Drawings: 604-051-105 and 604-999-105 for
complete details
PROPERLY SUPPORT THE OPERATOR HANDLE DURING THE REMOVAL AND IN-
STALLATION OF THE LATCH ASSEMBLY SO IT DOES NOT FALL AND CAUSE INJU-
RY.
ALL NECESSARY PERSONNEL PROTECTIVE EQUIPMENT - INCLUDING SAFETY
GLASSES - SHALL BE WORN WHILE PERFORMING THE FOLLOWING SERVICE
1. Using an Allen head wrench or Allen head socket, remove the SCREW, ¼-20UNC
X 1.50” FLAT HEAD SOCKET (000-143-709) and the ROD, LIFTING HANDLE
COATED (000-140-056) from the rear of the PLATE, HANDLE ADJUSTING (000-
105-764). Set the screw and the rod aside to be reused during reassembly.
2. Using an plyers and flat blade screw driver or a mechanics pick, remove both of the
RING, E-CLIP X ½” (000-139-009) from each end of the AXLE, WHEEL RX20 (000-
177-034).
THE RING, E-CLIP X ½” (000-139-009) HAS STORED ENERGY FROM TENSION. USE
EXTREME CAUTION WHEN REMOVING AND INSTALLING THEM
3. Remove each WHEEL, 8” from the AXLE, WHEEL RX20 (000-177-034) and set
them aside for reassembly.
4. Using an Allen wrench, remove both SCREW, ¼-20UNC X ¼” SET (000-143-737)
from the lock collars on each side of the BRACKET, HANDLE TO BASE-RX20
COATED(000-015-1327). Set them aside for re-use during re-assembly.
5. Using a ½” wrench or socket and socket wrench, remove the SCREW 5/16-18UNC
X ¾” LG (000-143-012) and WASHER 5/16 FLAT (000-174-049) from the PLATE,
HANDLE ADJUSTING (000-105-764). Set them aside for re-use during re-assembly.
6. Using a Allen wrench or Allen socket and a 7/16 wrench or socket, remove SCREW,
¼-20UNC X 1.75”LG SOCKET HEAD (000-143-008) and NUT, ¼-20 NYLOCK (000-
094-009) and set them aside for re-use during re-assembly.