Preface
We sincerely hope you enjoy your new Hydas electric foot warmer with
massage.The optimal combination of pleasant warmth and massage revives and
relaxes tired legs and aids circulation. This electric foot warmer has 2 motors
and heats the feet. All functions can be directed with the hand-held controller.
Introduction
For many years, new technologies for massage have been developed. These
are all designed to provide relief from everyday stresses.
Please note however, - this unit is designed for the consumer´s personal use,
and not with professional physical therapists in mind.
Contents and Technical Data
1 electric foot warmer with massage 33 x 25,5 x 12 (29,5)cm with operating
switch
1 power supply unit 230 Volt, 50 Hz, output 12V - 800mA, 9,6VA
Electric foot warmer with massage Equipment
2 motors and one heating device
The electric foot warmer has 2 built-in motors, which by vibrating provide a
pleasant massage. The feet are massaged when the switch is turned on.
At the same time you can select the intensity of the massage: low and high.
The motors can be controlled separately for the left and right foot. Massage and
warmth are independent on each other and can be selected separately or
combined.
For correct use of the operating switch, please refer to the Operating
Instructions before use.
Caution
- Do not use the electric foot warmer with massage
with a pacemaker
during pregnancy
if you have thrombosis
if you have pains of unknown origin
- Do not use the electric foot warmer with massage for longer than 15 minutes.
- Long periods of massage could lead to the electric foot warmer overheating.
- Interrupt the massage and wait until the electric foot warmer has cooled down.
The left foot massage is turned on by pushing
the switch into the position LO or HI.
The massage intensity can be varied between
the HI or LO setting.
The right foot massage is turned on by
pushing the switch into the position LO or HI.
The massage intensity can be varied between
the HI or LO setting.
The warmth is turned on by pushing the
switch to ON.
Flex socket for mains part
Before operating
- Put the electrical foot warmer with massage on the floor.
- Connect the plug of the mains part to the flex socket of the hand switch.
- Secure the 230V mains part to the mains.
Important Advice
- Disconnect from power supply after use! -
2
3
Operating Instructions
