Polígono Industrial O Rebullón s/n. 36416 - Mos - España - [email protected]
Servicio de Att. al Cliente
+34 986 288118
EN 7.613.5/03.19
232
Hydraulic circuit diagram
Sizing
As a rough guide, the FluidAqua Mobil
can be sized according to the tank
volume of the system.
Tank volume
in litres
FAM
< 2,000
FAM 5*
1,000 – 7,000
FAM 10/15** / 10**
7,000 – 15,000
FAM 25 / FAM 45E***
15,000 – 25,000
FAM 45
25,000 – 35,000
FAM 60
35,000 – 45,000
FAM 75 / FAM 75E***
> 45,000
FAM 95
* see Brochure no. 7.639 FAM 5
** see Brochure no. 7.949 FAM 10
*** see Brochure no. 7.654 FAM Economy
z
Select a larger size for systems with
very high and continuous process-
related water entry.
z
In contrast, for systems with just a
small amount of moisture entry via
tank breathing, one size smaller can
be selected.
z
Ideally the water content will be
measured periodically to determine
the water entry per hour/day. Our
sales specialists can then determine
the suitable size if they know the
oil type, oil temperature, operating
viscosity, system dimensions,
environmental conditions and target
water content.
In general, it must however be
noted that sizing will depend on the
application, the fluid, the temperature of
the fluid and the ambient temperature,
the fluid quantity and the water ingress
into the system. These factors have
a major influence on the dewatering
performance. The information can thus
only serve as a general reference.
Dewatering rate
Water content
Fluid
temperature
Detergent
additives
Flow rate of the
FAM
For dimensioning and project planning,
please use the FAM checklist,
doc. no.: 10000495854
1
Suction filter
16
Vacuum pump
2
AquaSensor AS 1000
17
Oil mist separator
3
Filling pump
18
Vacuum suction nozzle for
the oil mist separator
4
Non-return valve
19
Level sensor for vacuum column
5
Vacuum column
20
Pump for ContaminationSensor
CS1000 (optional)
6
Heater (optional)
21
ContaminationSensor CS1000
(optional)
7
Evacuation pump
22
Pressure relief valve for CS1000
(optional)
8
Check valve (FAM-25/45 only)
23
Pressure relief valve for CS1000
(optional)
9
Fluid filter for separating solid particles
24
Leakage indicator for oil drip tray
10 Differential pressure switch for monitoring
the filter
25
Drain for vacuum column
11
Drain for fluid filter
26
Return valve
12
Check valve (FAM-60/75/95 only)
27
Temperature sensor (for the heater 6
option)
13 Air filter and dryer
28
Drain for vacuum pump
14 Needle valve for vacuum setting
29
Level sensor for vacuum pump
15 Pressure sensor for measuring
the pre-set vacuum
Alarm
Max
Min
Water
Air
IN
Air
OUT
Oil
OUT
Oil
IN
Air
OUT
Polígono Industrial O Rebullón s/n. 36416 - Mos - España - [email protected]
Servicio de Att. al Cliente
+34 986 288118
Polígono Industrial O Rebullón s/n. 36416 - Mos - España - [email protected]
Servicio de Att. al Cliente
+34 986 288118
