Filtromat – OF5 C
1.2 Explanation
of
Symbols and Warnings, etc.
DANGER
DANGER denotes situations
which can lead to death if
safety precautions are not
observed.
WARNING
WARNING denotes situations
which can lead to fatal injury if
safety precautions are not
observed.
CAUTION
CAUTION denotes situations
which can lead to severe injury
if safety precautions are not
observed.
TIP
NOTICE denotes situations
which can lead to property
damage if safety precautions
are not observed.
1.3
General Safety Precautions
Operation, adjustment and calibration work may only be carried out by technically
skilled and trained personnel.
The safe operation of this unit can only be ensured if it is used for the purpose it was
intended. If there is any question about the use, please contact the manufacturer.
The manufacturer will not accept responsibility for damages resulting from misuse of
this equipment.
The following applies to all work performed using the unit: adherence to pertinent
national regulations pertaining to accident prevention and safety at the workplace in
addition to any applicable internal rules and regulations of the owner/operator, even
though they are not specifically cited herein.
Leaks of dangerous materials must be properly collected and disposed of so as not
to harm any persons or the environment. The corresponding statutory regulations
are to be followed.
Before any maintenance or repair work is carried out on the unit, electrical power to
the unit must be disconnected, and all hydraulic pressures relieved.
1.4 Proper/Designated
Use
The OF5 C was developed for the dewatering, filtration and degassing of hydraulic
and lubricating oils. It removes free water, emulsified water and a large percentage
of the water in solution.
Any other use shall be deemed to be improper and not in keeping with the product
designated use. The manufacturer will not assume any liability for any damage
resulting from such use.
HYDAC Filtertechnik GmbH
en
Page 9
BeWa OF5C 3160333a en
2008-02-06
