Preparing the CTM-EF for operation
CTM-EF 1000 series
en(us)
Page 24 / 52
BeWa CTM-EF 3509157c en-us 2018-10-18.docx
2018-10-18
Connecting the CTM-EF
The CTM-EF is delivered ready-to-connect. Before starting it up please note
or check the following:
•
Carefully read the operating and maintenance instructions for this
module, the CTM-SC as well as the CTM-SC software operating
instructions.
•
Take the support sieve supplied in the scope of delivery and put it in
the filter membrane holder.
•
Clean the clean room by using the rinsing of the inner chamber until a
negative control value is achieved as listed in the table on page 21 .
Attach the CTM-EF electrical connector and hoses for the control unit to the
CTM-SC as shown in the following illustration.
A
B
R
X
The test item to be examined is marked with an X.
Turn the connector by means of the locking ring to screw it securely onto the
socket.
The hose quick connectors must be pressed firmly onto the nipples, so that
the test liquid can flow.
