4
Starting Instructions
Please observe the starting instructions on the front of the powerpack.
Start:
Check engine oil level
Check hydraulic oil level at sight glass
Connect hoses and tool
Switch fuel tap to “ON”
Turn ignition key
Wait until engine warning light disappears
Activate electric start
Set the flow – see below
Stop:
Move all levers to “OFF“
Turn off the ignition switch
Turn the fuel tap to “OFF”
Setting of Flow
The powerpack has three connections, allowing for connection of two tools
simultaneously. The connections are marked A, B and C, respectively.
The oil flow can be adjusted by regulating the engine r.p.m. by means of the
throttle. Connection A can be set to 30-60 l.p.m. Connections B and C can be set to
15-30 l.p.m. Connection A cannot be used simultaneously with connections B and C.
Each connection is equipped with an ON-OFF lever. Connections not in use must be
set at OFF, and connections in use must be set at ON. Connections B and C can only
be used when connection A is OFF. Never turn the lever to ON if no tool is
connected.