Setting the target temperature
•
To set the target temperature of the heater use the
buttons on the touch
screen to cycle to the desired target value, allow the display to flash for several
seconds, when it stops flashing the display will show the new stored target
temperature.
Switching between Full/Half power
In order to use this feature, the remote control must be used.
•
Press the power select button
on the remote control to toggle between
Full/ Half
power setting. The current setting used will be displayed by the
power icons
on the display.
Manual mode
When the heater is in the manual mode (M), it will allow the user to simply switch the
heater on/off via the standby button
.
In this mode, the heater can be programmed to run on and automatically switch off
and go into standby at any specified time within the next 24hrs. The feature can only
be used via the remote control - see “Manual timer programming” section. Once the
pre-defined time is reached and the heater has switched itself off it will need to be
manually turned back on again at which point it will revert to operating in manual
mode.
It is strongly recommended to consider setting a timed operation using the
auto
mode where anticipated usage is predictable to avoid energy wastage.
Auto mode
This mode allows the heater to be operated by a user defined schedule. This offers up
to
four separate periods of operation to be defined for each day of the week. This
feature is
strongly recommended where heat demand is predictable as it can help
reduce energy
wastage. In addition, this allows spaces to be heated in anticipation of
the demand without the need for somebody to be present to turn it on; for example,
in an office
environment where staff arrive to begin work at 8.30am, turning the heater
on at 8am to pre-warm the room. The operating times can only be programmed into
the heater via the remote control (see “Auto timer programming” section).
Switching between
Manual
/
Auto
operation mode
•
Press the M/A select button on the heater touch screen to toggle between the
two modes. Confirmation of the current mode will be shown in text form on the
heater display.
7
.
.
.
•
T
urn on the display screen by pressing the standby on/off button.
•
T
urn on the display screen by pressing the standby on/off button.
