IMPORTANT SAFETY INSTRUCTIONS
Installation Safety Precautions
:
1. Never install telephone wiring during a lightning storm.
2. Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.
3. Never touch un-insulated telephone wires or terminals unless the telephone line has been
disconnected at the network interface.
4. Use caution when installing or modifying telephone lines.
The
HYBREX
GDS-1280 utilizes a 3 pin grounding power supply cord. This cord is not to be attached to
any building surfaces. When using your telephone equipment, basic safety precautions should always be followed to reduce
the risk of fire, electric shock and injury to persons, including the following:
1. Read and understand all instructions.
2. Follow all warnings and instruction marked on the
product.
3. Unplug this product from the wall outlet before
cleaning. Do not use liquid cleaners or aerosol
cleaners. Use a damp cloth for cleaning.
4. Do not use this product near water, for example, near a
bath tub, wash bowl, kitchen sink, or laundry tub, in a
wet basement, or near a swimming pool.
5. Do not place this product on an unstable cart, stand, or
table. The product may fall, causing serious damage
to the product.
6. Slots and openings in the cabinet and the back or
bottom are provided for ventilation, to protect it from
overheating, these openings must not be blocked or
covered. The openings should never be blocked by
placing the product on the bed, sofa, rug, or other
similar surface. This product should never be placed
near or over a radiator or heat register. This product
should not be placed in a built-in installation unless
proper ventilation is provided.
7. This product should be operated only from the type of
power source indicated on the marking label. If you
are not sure of the type of power supply to your home
or office, consult your dealer or local power company.
8. The socket-outlet shall be installed near the equipment
and shall be easily accessible.
9. This product is equipped with a three wire grounding
type plug, this plug will only fit into a grounding type
power outlet. This is a safety feature. If you are
unable to insert the plug into the outlet, contact your
electrician to replace your obsolete outlet. Do not
defeat the safety purpose of the grounding type plug.
10. Do not allow anything to rest on the power cord. Do
not locate this product where the cord will be damaged
by persons walking on it.
11. Do not overload wall outlets and extension cords as
this can result in the risk of fire or electric shock.
12. Never push objects of any kind into this product
through cabinet slots as they may touch dangerous
voltage points or short out parts that could result in a
risk of fire or electric shock. Never spill liquid of any
kind on the product.
13. To reduce the risk of electric shock, do not
disassemble this product, but take it to a qualified
service man when some service or repair work is
required. Opening or removing covers may expose
you to dangerous voltages or other risks. Incorrect
reassemble can cause electric shock when the
appliance is subsequently used.
14. Unplug this product from the wall outlet and refer
servicing to qualified service personnel under the
following conditions:
A. When the power supply cord or plug is damaged or
frayed.
B. If liquid has been spilled into the product.
C. If the product has been exposed to rain or water.
D. If the product does not operate normally by
following the operating instructions. Adjust only
those control, that are covered by the operating
instructions because improper adjustment of other
controls may result in damage and will often require
extensive work by a qualified technician to restore
the product to normal operation.
E. If the product has been dropped or the cabinet has
been damaged.
F. If the product exhibits a distinct change in
performance.
15. Avoid using a telephone (other than a cordless type)
during an electrical storm. There may be a remote
risk of electric shock from lightning.
16. Do not use the telephone to report a gas leak in the
vicinity of the leak.
-------------------------------------------------------
SAVE THESE INSTRUCTIONS