Figure 3 Assembly of Directors
to Boom
Select the remaining elements - D2, D3, D4, D5
and D6. Install these elements on the front and
mid-boom sections in the remaining holes in the
vertical plane. Refer to Figure 3.
After the installation of all elements, check each
exposed length from Table 1. Also check each
set of elements to make sure they are in the
proper order. If any element has to be adjusted
or moved, there are extra pushnuts supplied for
partial reassembly.
ATTACHMENT OF COAX ASSEMBLY
Select the coax/circularity-switch assembly
(Item 17), the No. 8 hardware (Items 35, 36, and
37), and the No. 10 hardware (Items 23, 29, and
34). Attach one of the two sets of terminals to
the front driven element's T-hars (Item 13), as
shown in FILUre 4. The No. 8-32 x 1/2 bolt is
used with the square lug=, and the No. 10-24 x
1/2 bolt is used with the round
luL,.
To achieve
proper phasing, attach the feedpoint solder lugs
as shown in Figures 5 and 6.
Summary of Contents for VB-216SAT
Page 3: ...Figure 1 Boom Assembly ...
