Hy-Gain HG-54HD, Manual, Page: 4 / 19

WARNING
Installation of this product near power lines
is dangerous. For your safety, FOLLOW
THE INSTRUCTIONS.
NOTE: If you are installing the Hy-Gain HDR-
300 Rotator on your tower, you will not be able
to nest the tower completely.
UNPACKING AND UNCRATING
GENERAL DESCRIPTION
This model is a 54-foot self-supporting tower
designed to support 16.0 square feet of antenna
area with winds up to 60 mph. This all steel
tower has a guide system that allows the
tubing to be open at each end insuring
complete galvanizing and total moisture
drainage.
The tower is extended from its nested position
by manual crank. A thrust bearing can be
bolted to the top section allowing a 2"
diameter mast.
Be sure to check your tower for any freight
damage or missing parts. If you find damage,
notify the trucking line that delivered the
equipment immediately and advise Hy-Gain of
the damage. Send a copy of the freight damage
claim to:
Hy-Gain
Telex Communications, Inc.
8601 East Cornhusker Highway
P.O. Box 5579
Lincoln, Nebraska 68505-5579
EQUIPMENT
The HG-54HD tower is supplied complete, in-
cluding reinforcing steel and base mount. The
tower corresponds to the drawings contained
in this manual. Refer to the Parts List section
for a complete breakdown of parts.
The Parts List shows the standard commercial
packaging. Any changes or modifications, if
any, which may be incorporated as the result
of special contractual agreements are covered
under
EQUIPMENT REQUIRED BUT
NOT SUPPLIED