C H A P T E R 4
Preparation for Assembly
FOR OUR OVERSEAS CUSTOMERS: The
United States uses English units of
measurements. Please refer to "Converting
English Measurements to Metric" in Chapter 4
for any conversions.
Choose a large clear area to assemble your
antenna. The area must be at least 3 feet by 45
feet (approximately 1 meter by 14 meters). If you
assemble the antenna over a grassy area,
precautions should be taken so that hardware is
not accidentally lost during assembly. A concrete
driveway is an excellent area for assembly.
TOOLS: The following tools are required for
easy assembly of the Discoverer 7-1.
When unpacking your antenna, check inside of
all tubing for parts (smaller tubing,etc.). To
conserve space, these smaller articles are
sometimes put inside larger pieces. Check all
parts against the Parts List to make sure no
parts are missing.
All tubing supplied with the Discoverer 7-1
telescopes together. Make all measurement to
the given dimensions, plus or minus (±), no
more than
1 / 8
inch! The assembly of this
antenna will be easier if you read this manual
completely through at least twice before
beginning assembly. Allow at least 2 hours for
assembly. Double and triple check ALL
dimensions after assembly.
Type of Tool Qty
Tape Measure, 12 foot
1
Adjustable Wrench, 8 inch
2
Nut Driver, 7/16 inch
1
Nut Driver,/8 inch
1
Nut Driver, 5/16 inch
1
Standard Hand Pliers
1
