Power/Volume
switch.
To turn
the
power on, rotate the knob clockwise.
further
rotation
will
increase the sound output
from
the speaker.
To turn the power
off,
rotate the knob counterclockwise
until the click is heard indicating
the power is turned
off from
the power supply.
Squelch
Control.
This control
is used to
eliminate
annoying
background
noise at no
signal.
To adjust
the squelch
control
properly,
first
turn
the knob
counterclockwise
until
background
noise is heard.
Then,
rotate the
knob
slowly
clockwise
until
the
background
noise just
disappears.
At
this
point,
the
receiver will
be relatively
quiet
under
no signal
conditions,
but
an incoming
signal will
overcome the squelch action
and be heard.
Since this control
is variable, it can be used to provide
varying
degrees of sensitivity
to incoming
signals.
As the control
is
advanced
from
the
extreme
counterclockwise
position
the squelch
action
is progressively
increased and stronger
signals are needed to
overcome
it.
To
receive extremely
weak signals or to
disable the
squelch circuit,
simply turn the control
fully
counterclockwise.
Channel Selector.
Continuously
rotating
switch
selects anyone
of
23
channels
for
transmit
and
receive
operation.
Mic
Jack.
Connect
the
push-to-talk
microphone
or
the
optional
telephone
handset.
Signa I Strength/R F
Power
Meter.
During
reception,
the built-in
meter
provides a relative
indication
of
signal strength
in "S"
units on the upper scale and offers comparison
between one incoming
signal and another.
During transmit,
this will
provide an indication
of antenna
RF power
on the
lower
scale.
As you
speak, the
pointer
shou Id "flicker"
slightly,
indicating
that you are modu lating the R F carrier.
CB Transmitter
Operation
IMPORTANT:
Do not
try
to
transmit
without
a citizens
two-way
antenna
connected
to
the
antenna
connector
on the
rear
panel.
1.
Turn
the
power
on.
2.
Turn channel selector to a desired channel.
3.
Depress the
push-to-talk
button
on the microphone.
Hold the
microphone
4 to 6 inches from
the mouth.
Speak at a normal
level.
During
periods
of transmission,
the
receiver
is silenced
and reception
is therefore
impossible.
In the same way,
your
signal can not be heard by another station when he is transmitting
each must take turns.
4.
To receive, simply
release the
microphone
push-to-talk
button.
