HY-CLOR poseidon, Installation & Operation Manual, Page: 5 / 14

To assemble the entire cleaner body the following steps are to be taken.
• Hold the body assembly in an upside down position either placed on a table or fi rmly between your knees and slip
the pleated seal over the foot assembly. This may require a little effort to place over the foot however it will not
split if a little force is used. Ensure the pleated seal is the correct way up with the fl at surface facing toward you
looking at it from the assembly position. The pleated seal is to be seated between the foot and round plastic part
of the cleaner body which is a recess. Another way to install the pleated seal is to slide it down over the top of the
cleaner which may be easier for some people.
• Turn the body around into the upright position to connect the ring fl oat assembly.
• Place the ring fl oat assembly over the cleaner body. The fl oat faces toward the front of the cleaner with The ring
and fl oat facing toward the top of the cleaner. Clip it into the body clip recess. The clip recess is a moving part
located just below the two clear tubes.
• Add the rear bumper fi n to the cleaner into the two slots on the cleaner body. The bottom one is located at the
back of the cleaner body as shown below and the top slot is located on the back side of the rear clear tube where
it connects to the top chamber. The rear bumper fi n must be placed outside of the ring fl oat assembly as shown
in the photo below, and is to be inserted before connecting to the top slot. Insert the rear bumper fi n from the
bottom slot fi rst.
Connecting the hoses together requires the use of the silicon grease in the tube or tub provided with the POSEIDON
TM
Automatic Swimming Pool Cleaner. Each male section of hose is to be lubricated to allow for easier connection.
Poseidon Auto Pool Cleaner Manual.indd 6 Poseidon Auto Pool Cleaner Manual.indd 6 28/7/10 2:07:43 PM 28/7/10 2:07:43 PM