1. Remove the wing nut,washer and felt pad
1. Remove the wing nut, washer and felt pad
2. Put the cymbal pad into the rod along with
parts removed in step 1.
Tighten
the wing nut
modertly to give the pad a little bit wobbling like
the real acoustic cymbal.
Note:
Crash and Ride have different part names.
Please refer to indication on page 5.
3.Adjust the angle of the rod then tighten the
wing nut.
1. Insert the snare into the L-Rod, then tighten
the wing nut.
2. Put the Hi-Hat into the rod along with parts
removed in step 1. Fasten the wing nut.
2. Adjust the angle of the L-Rod then tighten
the wing nut in the clamp.
Hi-Hat Installation
Crash and Ride Installation
Snare Installation
1.
Insert the tom into support arm, then adjust its position
and angle. Tighten the screw with the screw driver included.
Note:
All the toms use the same pad.
Tom Installation
COMPONENTS INSTALLATION
1. Align holes in supporting board with these in sound module
then fasten them with screws.
2. Insert rod of the supporting board into the clamp, then tighten the
wing nut.
Sound module Installation
Please refer to the SOUND MODULE Chapter for electronic connection.
Electronic Connection
Finalizing the Installation
Adjust arms, clamps and rods to the best position you like to finalize the installation.
INSTALLATION
8
2
1
3
2
1
1. Adjust the beater to this position.
2. Attach the kick pedal to kick pad,
then fasten the lock nut.
1
2
