HWAM 3420, User Manual

Page: 43 / 52

43
5. Removing the flue ring (4). Remove the three screws. Lift the flue ring off the top of the stove.
6. Installing the flue ring (4). Insert the flue ring into the smoke outlet hole in the rear of the stove and
secure it with the three screws.
7. Installing the cover plate (3). Place the cover plate above the hole on the top of the stove and secure
it with the three screws.
8. Installing the rear plate (2). Place the rear plate on the guide pins at the back of the bottom plate of
the stove; then press it in towards the stove. Lift the rear plate and press it lightly inwards until it
engages with the guide pins.
9. Installing the top plate of the stove (1). Place the top plate on the fittings and secure it with the four
screws, two on each side.
10. Installing sides. Put the sides on the guide pins in the bottom plate of the stove and press them in towards
the stove. Lift the sides and press them lightly inwards until they engage with the guide pins.
Connection to chimney
All the stoves have both rear and top smoke outlet that can be connected to an approved steel chimney on
top or directly out at the rear to a chimney.
Make sure that the chimney is tight and that no false draft is caused around neither the cover plate, in
connection with a covered smoke outlet, nor the cleanout door and pipe connections. Please note that
bent and/or horizontal smoke pipes will reduce the effect of the chimney draft.
Vertical cross-section of smoke flue (Drawing B and C)
B: Top smoke outlet
C: Rear smoke outlet
• Steel chimney (9).
• Flue gas elbow (10). Fits into smoke flue socket.
• Brick-built jamb of flue (11).
• Built-in pipe sleeve (12). Fits smoke flue.
• Wall rosette (13). Covers disruption to wall around pipe sleeve.
• Joint (14). Sealed with packing material.
• Smoke outlets (15) of the HWAM stove.
• Smoke flue regulating damper (16).
• Soot door (17).
Fitting the loose parts
Before the stove is installed, you must ensure that all loose parts are fitted correctly.
Vertical cross-section of the stoves (Drawing B):
• The smoke shelf (5). To be placed on top of the steel rail and on the holders in the sides.
• Two-piece smoke defector plate (6). Each half is hung on the hooks located beneath the top plate. The two
halves join in the holders behind the air pipe. Once the stove has been installed, twist the protection off
the two hooks by using pliers or a screwdriver.
• Cover plate (7). Should always cover the grate.
• Removable rear plate (2), covering automatic controls. This must always be mounted if the stove is
placed next to a combustible wall.
• Loose heat shield (8) under the ash pan. This can be used as a lid when the ash pan is removed for
emptying.
Cover plate (Drawing D)
Your HWAM woodburning stove is supplied with a loose cover plate for the shaking grate. This is a 3
mm thick iron plate. It is placed on top of the shaking grate and prevents the embers from falling into