HW Group I/O Controller 2, Manual

Page: 31 / 44

I/O Controller 2 Manual HW group
www.HW-group.com 31/ 42
------- I/O control -------
#E: GPIO control from UDP Off
#J: Port
24
When enabled, commands to change output states can be sent to the I/O Controller over UDP as
well as over TCP.
#J defines the UDP port where the I/O commands need to be sent.
#S: Send to IP 192.168.0.252
#U: Port 4024
When the UDP GPIO Control mode is enabled, I/O Controller sends the state changes to the
specified address and port.
#V: GPIO control from COM Off
When enabled, I/O Controller inputs and outputs can be controlled over the serial line. Commands
are similar to NVT commands
– 0xFE prefix followed by a NVT command. For example, 0xFE 0x33
xx sets the output to xx. The prefix is the same as for the &V command.
System
========= Other =========
D: Load/Save Settings from/to Flash
Saves the current settings to memory, or restores saved settings.