Huvema HU 200-4 DB, Operating Instructions And Parts Manual

Page: 11 / 20

11
Setting and Adjustment
Support adjustment
Adjust the support plate J ( Fig 6 ) to
near the brush as close as possible
Protect Cover adjustment
Adjust the cover K (Fig 6) to against the
chips .
Brush's access protection
To enter the brush , operate as follows:
1. Check that Stop Motor Switch F
(Fig.4) is off.
2. Disassembly the plug
3. Disassembly screw L (Fig.7) then
take out the cover M (Fig.7)
4. Pull a shaft or hex-wrench O (Fig 9 )
to stop the hole N (Fig 8)
5. use the wrench P (Fig 9) to take out
the screw S ( Fig11)
Fig 6
J
Fig 7
L
M
N
K
Fig 8