12
changes and t yping errors reserved
changes and t yping errors reserved
changes and t yping errors reserved
Picture U – electrical diagram
1 Motor
5
power cord (option)
2 Motor cord
6
Micro switch (option)
3 greed
7
Micro switch for chuck guard assemby
4 Main switch
4. p
reparaTions
Picture A - Parts
on receipt, carefully unpack the components ensuring that no damage was suffered in transit and that all parts are
accounted for. the following loose items are to be found in the packing case:
a
table assembly (various models)
F
head assembly
B
arm
g
Box of loose parts
c
Manual
h
chuck guard assembly (optional)
d
Bag of loose parts
J
column assembly
e
Base
check the parts against the above list and refer to the pictures. should there be any deficiencies or damage, please
contact your huvema dealer immediately.
l
oose
iTems
in
box
and
bag
Picture B – Loose items
1
allen key, 3/4/5 mm
7
pulley cover knob with pan head screw M5
2
Worm
8
idler pulley
3
chuck (option)
9
v-belt (2x), M24 M26, a27 a29
4
table crank
10
Feed lever
5
hex. head screw (4)
11
Wedge drift
6
support lock handle
5. a
ssembly
Warning!
For your own safety, never connect plug to power source outlet unti all assembly steps are
completed.
Picture C – Tools needed
screwdriver(s)
combination square
inch adjustable wrench
combination square must be true. check its accuracy as illustrated:
2a.
Use straight edge of board ¾” thick. this edge must be perfectly straight.
2b.
draw light line on board along this edge.
2c.
there should be no gap or overlap when square is flipped over in dotted position.
5.1 a
ssembly
of
colUmn
and
Table
hardware
Picture D – Column and table support
1.
position base (1) on floor. remove protective covering and discard.
2.
remove protective sleeve from column tube and discard. place column assembly on base and align holes in
column support (2) with holes in base.
3.
Locate four 10 x 40 mm bolts (3) in loose parts bag.
4.
install a bolt in each hole through column support and base and tighten with adjustable wrench.
Summary of Contents for HU 16 T
