Huvema CRDM 3050 x 16/1, Operation Manual

Page: 6 / 66

6
1.1.28 Keep your hands away from the moving parts of the machine during
operation.
1.1.29 When removing chip iron around the tooling system, avoid taking them out
directly by hand, there is cutting hazards. It is safer with proper tool when doing
this. Be sure to stop the machine when removing chip from the machine.
1.1.30 Prior to starting test operation, read this manual carefully so as to be
familiar with the machine.
1.1.31 Contact the manufacturer if for some reason about some of the
OPERATION MANUAL become unreadable.
1.1.32 When install a tool, stop the spindle and the feed in each axis.
1.2 Additional Safety Rules Of Machine
1.2.1 Must read and understand the entire instruction manual before operating the
machine.
Warning: Failure to comply with this instruction may cause serious injury.
1.2.2 Always wear approved safety glasses/suit while operating machine tool.
1.2.3 Make sure the machine is properly grounded.
1.2.4 Before operating the machine, remove tie, rings, watches, other jewelry,
Keep the quills and the edges of the work uniform tight. Always be sure to
wear safety goggles and wear safety shoes during operation. Do not wear
gloves while operating machine tool.
1.2.5 Keep the floor around the machine clean and away from scrap materials, oil
and grease , etc.
1.2.6 Keep all guards of the machine securely in place at all times when working.
For maintenance purpose, use extreme caution and replace the guards
immediately after maintenance.
1.2.7 Make sure workpiece and cutter be fitted and clamped well, and make sure
the cutter doesn't touch the workpiece before starting the machine.
1.2.8 Must shut off power supply before adjusting or maintaining the machine.
1.2.9 The operator must keep clear-minded when operating the machine and pay
attention to what he is doing. It is not allowed to operate the machine when the
operator is tired, after drinking or taking medicines.