General Information
Note:
When ordering parts, you must use the part number as shown for each part, not the index number. Always give
the model and serial number to your parts and service representative.
Note:
Items sold in bulk such as seals and hoses are sold by the foot.
Using This Manual
This manual is part of a service package for the Hustler
®
mowers. Use of this manual in conjunction with other Hustler
®
mower and component manuals will provide the information necessary to service and maintain Hustler
®
mowers.
This Parts Manual provides a complete parts listing for the unit. Use this manual when ordering parts. Illustrations used
were current at the time of printing, but subsequent production changes may cause your machine to vary slightly in
detail. Excel Industries, Inc. reserves the right to redesign and change the machine as deemed necessary, without noti-
fication. If a change has been made to your machine which is not reflected in this parts manual, see your authorized
dealer for current information and parts.
The Service Manual is a service guide for use by Service Technicians. It provides the necessary information needed to
perform normal maintenance requirements on these units.
The Operator's Manual provides fundamental operational information and operational safety that is needed when oper-
ating the mower.
The component manuals are furnished by the various manufacturers to be used for the troubleshooting and servicing
of their products.
Hardware Description Codes & Abbreviations
The following codes are used throughout this parts manual. Refer to this list when ordering parts.
ABBREVIATION
CARRIAGE BOLT
MACHINE BUSHING
CLEVIS PIN
MACHINE SCREW
CLIP NUT
NUT
COTTER PIN
SELF TAPPING CAP SCREW
CAP SCREW
SOCKET HEAD
CUP WASHER
SHOULDER BOLT
FENDER WASHER
SET SCREW
FLAT WASHER
OUTSIDE DIAMETER
HEX HEAD
INSIDE DIAMETER
LOCK WASHER
WELD NUT
Standard Torques
The following chart lists the standard torque values for the threaded fasteners found in this manual. Torque all cap
screws, nuts and set screws to these values unless a different torque is shown in the Notes section next to the fastener.
SIZE
FT-LBS
N•M
SIZE
FT-LBS
N•M
DESCRIPTION
ABBREVIATION
DESCRIPTION
CB
MB
CE
MS
CN
NT
CP
SC
CS
SH
CW
SB
FDRW
SS
FW
OD
HX
ID
LW
WN
.250
8.2
11.1
M3
1
1.3
.312
17
23
M4
2.2
3
.375
30
40
M5
4.5
6.1
.438
48
65
M6
7.7
10.4
.500
73
99
M8
18.5
25
.562
105
143
M10
37
50
.625
145
200
M12
64
87
.750
260
350
M14
80
108.5
.875
420
565
M16
160
215
1.00
625
850
M20
320
435
M24
555
750
