Rev. 0505
1 3
Maintenance cont’d
Glass Sweep Installation
(WHERE APPLICABLE)
PARTS LIST
• Silicone 1200 (or comparable)
• Masking tap (not supplied)
INSTRUCTIONS
1.
Cut a strip of the glass sweep material to the proper
length.
2.
Open glass wide enough to apply a few small drips of
#1200 silicone down the edge of one side of the glass.
Space each drop about 4” apart.
3.
Apply the glass sweep strip to the freshly siliconed
end, making sure to align the edges top and bottom.
Carefully wipe up any excess silicone that may be
bubbling up from the edges.
4.
Apply tape across the strip, to hold it in place on edge
of glass until the silicone has a chance to properly dry
(approximately 30 minutes).
5
Repeat process for strip on the other edge.
ELECTRIC AL PREC AUTIONS
BEFORE
SERVICING
Always Disconnect Electrical
Power at the Main Disconnect
when servicing or replacing
any electrical component.
This includes (but not limited to) Fans,
Heaters, Thermostats, and Lights.
ALWAYS DISCONNECT ELECTRICAL POWER AT THE MAIN
DISCONNECT WHEN SERVICING OR REPLACING ANY
ELECTRICAL COMPONENT.
This includes (but not limited
to) fans, heaters, thermostats, and lights.
TIPS & TROUBLESHOOTING
BEFORE CALLING FOR SERVICE IF SOMETHING
SEEMS WRONG, CHECK THE FOLLOWING:
1. Check electrical power supply to the equipment for
connection.
2. Check fixture loading. Overstocking case or blocking
airflow will affect it’s proper operation.
3. If frost is collecting on fixture and/or product, check
that Humidity Control is working properly, and that
no outside doors or windows are open—allowing
moisture to enter store.
FOR PROMPT SERVICE
When Contacting the Factory
regarding problems, Be sure
to have the Case MODEL and
SERIAL NUMBER Handy.
This Information is on a plate
located on the case itself.
