8
P/N 3091736_C
U.S. & Canada 1-800-922-1919 • Mexico 1 800-890-2900 • www.hussmann.com
REFRIGERATION UNIT ACCESS
The rear front panel may be removed by lifting
the panel straight upward and over the tabs
on which it is hanging. Screws will have to
be removed from either end of the panel. The
panel is installed by reversing the above procedure.
Ensure lower front panel is flat against the
floor when installed to prevent air circulation
problems.
SEALING MERCHANDISER TO FLOOR
If required by local sanitary codes, or if the
customer desires, merchandisers may be sealed
to the floor using a vinyl cove base trim. The
size needed will depend on how much varia-
tion there is in the floor, from one end of the
merchandiser to the other. Sealing of the lower
front and rear panels on self contained mod-
els may hamper their removal for servicing or
maintenance of the condensing unit.
NOTE:
Do not allow trim to cover any intake
or discharge grilles located in the lower front
panel.
MERCHANDISER ELECTRICAL DATA
Refer to the merchandiser’s serial plate for
electrical information.
FIELD WIRING
Field wiring must be sized for component
amperes stamped on the serial plate. Actual
ampere draw may be less than specified.
POWER SWITCH
The main electrical power switch is located
behind the front louvered access panel. The
power switch must be turned OFF before
servicing the merchandiser.
ELECTRICAL CONNECTIONS
All wiring must be in compliance with NEC
and local codes. This model is provided with a
power cord.
ALWAYS CHECK THE SERIAL PLATE FOR
COMPONENT AMPERES
Merchandiser must be grounded.
Do not remove the power supply cord ground.
SERIAL PLATE
REMOVE REAR PANEL
