2-8
ELECTRICAL / REFRIGERATION
P/N 9FQ-6-P110-075-00_B
U.S. & Canada 1-800-922-1919 • Mexico 01 800-890-2900 • www.hussmann.com
SHELVES
Shelves should be loaded so that the product
does not extend over the front edge of the shelf .
Product loaded over the edge will interfere with
air circulation in the cabinet .
• Display items in such a way that will not
protrude from the shelf / deck pan .
• Display the items uniformly on shelf / deck
pan .
• Do not place items more than 155 lbs on
deck pan and shelf .
• After removing the items, adjust the height
and angle of the shelf .
• Adjust height and angle according to the
product .
• The shelf height can be adjusted at 0 .59 inch
intervals .
• Change the angle of the shelf with the hook
as the fulcrum .
STOCKING
Product should NOT be placed inside the
merchandisers until merchandisers are at
proper operating temperature .
Allow merchandiser 24 hours to operate before
loading product.
Proper rotation of product during stocking is
necessary to prevent product loss . Always bring
the oldest product to the front and set the newest
to the back .
Air discharge and return flues must remain
open and free of obstruction at all times to
provide proper refrigeration and air curtain
performance . Do not allow product, packages,
signs, etc . to block the air inlet and air outlet .
Do not use unapproved shelving, baskets, dis-
play racks, or any accessory that could hamper air
curtain performance . Contact your Hussmann
representative for more information .
DRAIN WATER
If the evaporation mechanism is attached,
drainage work is unnecessary if the outside air
temperature is 80°F, the humidity is 55% RH,
and the ambient wind speed is less than 47 .2 FPM .
During the summer and on high-humidity days,
check the overflow drain pan at the bottom of
the case, and throw out any excess water (See
location illustration on Page 1-3) .
RE-START
Leave the product in the case for at least 5 minutes
before re-starting the case .
If the merchandiser is re-started immediately
after stopping, the overload protection unit or a
breaker for wiring may trip, or an excessive load
may be applied to the compressor, which will
result in failure .
For energy savings:
Please turn off the lights at night and at the time
of closing the store . When night curtains are
provided, pull them down during off hours to
enhance product quality .
Do not block the discharge air outlet
and return air inlet with products.