HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 (Printed in U.S.A.)
SPLASHGUARD BRACKET
AND JOINT SUPPORT
Install Splashguard Bracket
Position splashguard brackets to the merchandiser
and level to the floor. Each bracket has a 1
1
/
2
in.
(38 mm) slot at the rear of the bracket where it
attaches to the merchandiser. Tighten screws to
secure the brackets.
Install Splashguard Joint Support
Position the joint support across the brackets as
shown above. Fasten with hex head sheet metal
screws.
OFFSETTING BUMPERS AND TOP RAIL
Offsetting the bumpers and glass trim helps to
disguise the joint locations, giving the lineup a
smoother look.
1. Locate 2 ft (610 mm) starter bumpers and glass
trim. They are shipped with the left-end kit.
2. Remove factory installed glass trim and
bumpers from cases as follows:
a
.
Standard plastic glass trim is friction fit.
Start at left end and lift up, moving to right
end. Pry tools will damage trim.
b. Remove upper and lower bumpers by
pulling bumper away from bumper retain-
ers. Be careful not to misplace the internal
joint trims from the upper bumpers.
3. Starting at the left end of the line up, install the
upper bumper starter section first. To install:
a. Position internal joint trims so that the first
is flush to the left-end panel and the second
is centered between the starter bumper and
the full length bumper as shown.
b. Install full length bumpers and internal
trims offset across joints. Make sure that
no gaps exist between sections. Continue
installing the upper bumpers the length of
the line up. Do NOT install the last bumper
section at this time. This section will be
installed in the last step.
Bracket
Base of Case
Joint Support
Screw
Upper
Bumper
Pull
Internal
Joint Trim
