1-14
I
nstallatIon
P/N 3093114_A
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • WWW.HUSSMANN.COM
Seal Glass Front
Apply
Silicone
Sealant
Apply
Silicone
Sealant
Apply
Silicone
Sealant
Apply
Silicone
Sealant
INSTALLING END ASSEMBLIES
End assemblies are normally factory installed.
The following information is provided for
retrofit or field installation.
1. Prepare Merchandiser
a. Remove display racks, pans, front rack
supports and front air grilles from section
of case where end is to be installed.
b. Remove the interior back panel.
No tools required.
2. Apply gaskets to end frame
3. Fasten End Assembly to Merchandiser
a. Use Bolt and washer to fasten end
assembly to merchandiser in the same way
the end merchandiser is fastened.
b. Tighten in order shown for joining.
4. Seal End to End Frame
Remove front shelf and shelf support bracket.
Apply a
1
/
2
in. bead of Silicone at the back of
the case, starting at the first slot. Continue
across the bottom and up the front as shown
below. Use field-supplied silicone in any gap
between front support bracket and end assembly.
Re-install bumpers as described beginning on
Page 1-13.
5. Install End Splashguard Bracket
Insert back of bracket through slot in leg.
Use Screws to attach End Splashguard
Retainer to end frame.
INSTALLING PARTITIONS
To join same temperature fixtures on differ-
ent defrost cycles, an acrylic partition kit is
required.
To join unlike fixtures, or like fixtures operating
at different temperatures, an insulated partition
kit is required. It must be installed when setting
the lineup. Instructions for installing these
partitions are included with the kits.
