Husqvarna TC 50 2023, Owner'S Manual

Page: 99 / 196

WHEELS, TIRES 13
97
V00281-12
(TC 50 MINI)
–
Clean and grease wheel spindle
1
.
Long-life grease ( p. 139)
–
Position rear wheel and mount the chain.
The brake linings are correctly positioned.
–
Insert wheel spindle
1
with washer
2
.
–
Position washer
3
. Mount nut
4
, but do not tighten it
yet.
–
Make sure that the chain adjuster support plates are in
contact with the adjusting nuts.
–
Check the chain tension. ( p. 68)
–
Tighten nut
4
.
Guideline
Nut, rear wheel
spindle
M12x1 40 Nm (29.5 lbf ft)
–
Operate the foot brake lever repeatedly until the brake
linings are in contact with the brake disc and there is a
pressure point.
Finishing work
–
Remove the motorcycle from the lift stand. ( p. 42)
13.5 Checking the tire condition
Info
Only mount tires approved and/or recommended by Husqvarna Motorcycles.
Other tires could have a negative effect on handling characteristics.
The type, condition, and pressure of the tires all have a major impact on the handling characteristic of
the motorcycle.
The tires mounted on the front and rear wheels must have a similar profile.
Worn tires have a negative effect on handling characteristics, especially on wet surfaces.
400602-10
–
Check the front and rear tires for cuts, embedded objects,
and other damage.
» If the tires have cuts, run-in objects, or other damage:
–
Change the tires.