Husqvarna TC 50 2023, Owner'S Manual

Page: 26 / 196

8 RIDING INSTRUCTIONS
24
Info
If the motorcycle is unwilling to start, the cause can be old fuel in the float chamber. The flammable ele-
ments of the fuel evaporate after a long time of standing.
If the float chamber is filled with fresh fuel, the engine starts immediately.
Preliminary work
–
Raise the motorcycle with a lift stand. ( p. 42)
The motorcycle has been out of use for more than 1 week
–
Empty the carburetor float chamber.
–
Turn the knurled screw on the fuel tap all the way counterclockwise.
Fuel can flow from the fuel tank to the carburetor.
The engine is cold
(TC 50)
–
Pull the choke knob up all the way to the stop and turn it by a max. ¼ turn.
(TC 50 MINI)
–
Push the choke lever up all the way to the stop.
–
Forcefully step on the kick starter lever, pushing it all the way forward.
Info
Do not open the throttle.
Final steps
–
Remove the motorcycle from the lift stand. ( p. 42)
8.3 Starting off
Info
The plug-in stand must be removed before riding.
–
Open the throttle carefully.
8.4 Riding
Info
If unusual noises occur while riding, stop immediately, switch off the engine, and contact an authorized
Husqvarna Motorcycles workshop.
–
If the choke function has been activated, deactivate it after the engine has warmed up.
–
After reaching maximum speed by fully opening the throttle grip, turn the throttle back so it is ¾ open. This
will barely reduce the speed, but fuel consumption will be considerably lower.
–
Your child should always open the throttle only as much as the engine can handle
–
abruptly opening the
throttle increases fuel consumption.
–
Your child should switch off the engine if prolonged operation at idle speed or while stationary is imminent.
Guideline
≥
2 min