Husqvarna Soff-Cut 4200, Operator'S Manual

Page: 2 / 18

CONTENTS
Content Page
Table of contents ………………………….. 2
Unpacking .................................................. 2
Transporting ............................................... 2
Sound Data ................................................ 2
I
ntroduction, personal safety ...................... 3
Registration of the product ………………… 4
General safety message ............................ 4
Safety warnings ......................................... 5
Excel series blades ................................... 6
Blade and skid plate installation ................ 6
What is what? ............................................ 7
Operating instructions ............................... 8-9
Fuel and fuel safety warnings …….…….... 10
Recommended fuels ................................. 10
Recommended oils …….......……….…..… 10
Engine and transmission maintenance ..... 11
Other maintenance ………………….…….. 12
Sawing contraction joints …………....….… 13
Maximizing the Soff-Cut system .......…..... 14
Troubleshooting ......................................... 15
T
echnical specifications .............................
16
Conformity certificates ...............................
16
Warranty .................................................... 17
Your
4200
saw has been shipped from the factory thoroughly
inspected. Only minimal assembly is required to start using
the saw. Remove the saw from the container using proper lift-
ing techniques. Discard or recycle the packing material per
your regional laws. In your container will be the
4200
saw,
diamond blade, skid plate, blade shaft wrench, spark plug
wrench, an owner’s manual, an engine owner’s manual, a part
list, a warranty card, a joint protector sample pack and a ramp
for unloading the saw. Connect the battery cables and turn the
key switch to the “ON” or “1” position on the instrument panel.
Press the rocker switch on the instrument panel to raise the
saw. Place the unloading ramp at the edge of the container
and roll the saw out of the container. Lower the saw and turn
the key switch to the “OFF” or “0” position.
CAUTION
Only use the side and front lifting
handles when lifting the
4200
.
The
4200
saw weights approximately 496 pounds (225 ki-
lograms) when ready to use . Use safe lifting practices when
handling the saw. Always remove the diamond blade when
transporting the saw. Always transport the saw with a skid
plate installed. Retract the guide arm. The saw can be lifted
from the side and front handles or using the optional lifting kit
and sling. Always store and transport the saw in a completely
lowered position and secured from moving.
UNPACKING
2
TRANSPORTING
Instrument
panel
Lifting point
Lifting point
Hood
Lifting point Front guide