4
–
English
Ser
vice journal
Pre-deliver
y service
1
Charge the battery for 4 hours at max. 3 amp.
2
Fit steering wheel, seat and any optional
equipment.
3
Check and adjust tyre pressure (60 Kpa, 0.6 bar,
9 PSI).
4
Adjust cutting unit:
Adjust lift springs (effective weight of cutting unit
should be 12-15kg / 26.5-33 lb).
Adjust cutting unit so that rear edge is about 2-4
mm / 1/8” higher than front edge.
Adjust cutting unit height setting so that cutting
height limit is 5 mm / 3/16” above the frame of the
unit at the lowest cutting height.
5
Check that the right amount of oil is in the engine.
6
Check that the right amount of oil is in the
transmission. (Not Rider 11).
7
Connect battery.
8
Fill with fuel and start engine.
9
Check that machine does not move in neutral.
10 Check:
Forward drive.
Reverse drive.
Operation of blades.
Seat safety switch.
Lif lever safety switch.
Safety switch for the hydrostat pedals/neutral
position.
Check engine speed. See the Technical data
section.
11 Check the synchronisation between the front and
rear wheels. (Rider 16 AWD) See the workshop
manual.
12 Tell customer about:
Needs and benefits of following the service
schedule.
Servicing and the influence of this journal on the
second-hand value of the machine.
Range of applications for BioClip.
Complete proof of sale etc.
Pre-delivery service carried out. No outstanding problems.
Certified:
_________________________________________________________
Date, mileage, stamp, signature
After the first 8 hours
1
Change engine oil
2
Change the oil in the gearbox. (Only AWD-
machines)
3
Check the synchronisation between the front and
rear wheels. (Only AWD-machines)
